Defy DHG 117 Owner's Manual download pdf (Page 10)

Page 10

• To switch a burner on, push down slightly

on the relevant control knob and then turn

it to the left ( counter – clockwise ) The

large flame symbol on the knob indicates

the maximum and the small flame the

lowest setting.

• The gas will then be lit automatically.

• Release the knob 3 to 5 seconds after the

flame is observed at the burner.

• If the flame fails to continue burning,

please repeat the sequence.

Operating the burners

The control panel.

0 0 0 0

LEFT FRONT

BURNER

LEFT BACK

BURNER

RIGHT FRONT

BURNER

RIGHT FRONT

BURNER

Screwdriver is supplied

with accessories

Highest minimum adjustment

Lowest minimum adjustment

BURNER BODY

BURNER CAP

FLAME FAILURE SENSOR

IGNITION

ELECTRODE

• Carefully align the hole in the aluminium

burner body with the flame failure sensor.

• Gently lower the burner body into position.

• Centralise and level the burner cap onto

the burner body.

Fitting the burner caps.

• Remove the push-on-type knobs.

• Light the burners and adjust the minimum

flame by turning the adjustment screw

clockwise to decrease or anticlockwise to

increase the flame.

Minimum flame adjustment

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments